(Polyphenyl Sulfone - Polyether Sulfone) Blending to Performance Flat Sheet Membrane to Remove Some Heavy and Radioactive Elements from Phosphogypsum Waste

Authors

• Waleed T.Rashid, Production Engineering and Metallurgy Department, University of Technology ,Baghdad, Iraq, 70129@uotechnology.edu.iq
• Israa A. Alkadir, Production and Metallurgy Engineering Department, University of Technology ,Baghdad, Iraq 40007@uotechnology.edu.iq
• Moayyed G. Jalhoom, Consultant-Production and Metallurgy Engineering Department, University of Technology, Baghdad, Iraq moayyedgassid@yahoo.com
• Khalid T. Rashid, Chemical Engineering Department, University of Technology, Baghdad, Iraq 80007@uotechnology.edu.iq

Keywords

Ultrafiltration, rejection, heavy elements, radioactive elements

Document Type

Research Paper

Abstract

In this research, the traditional version of the phase inversion method was used to fabricate a flat sheet of a blended membrane. The method was involved using a polymer that blends polyether sulfone (PES) varied proportions (0,3,4 and 5 wt.%), and polyphenyl sulfone (PPSU) was 20wt%. It was found that with the addition of PES, the membrane properties increased, the best properties were with 4%wt. The ratio was chosen PES 4wt% to study the effect of time, temperature, and pressure on the rejection of heavy and radioactive elements. The increase in the porosity was with the addition of 4% PES. The rejection of heavy and radioactive elements for thUF membrane increases with increasing of the operating pressure and time. While by increasing the temperature, the rejection of heavy and radioactive elements for thUF membrane decreased. The rejection of K, Th, and Pb are higher than other elements, the order of the rejection is K˃Th˃Pb˃U˃Cd˃Zn˃Cu>Ni.

Recommended Citation

T.Rashid, Waleed; A. Alkadir, Israa; G. Jalhoom, Moayyed; and T. Rashid, Khalid () "(Polyphenyl Sulfone - Polyether Sulfone) Blending to Performance Flat Sheet Membrane to Remove Some Heavy and Radioactive Elements from Phosphogypsum Waste," Engineering and Technology Journal: Vol. 39: Iss. 3, Article 4.
DOI: https://doi.org/10.30684/etj.v39i3A.1762

DOI

10.30684/etj.v39i3A.1762

First Page

382

Last Page

393